MikroElektronika Forum

Hi,

I had bought a glcd months ago. I wanted to adopt it to my project board. I checked the glcd controller and saw that it was SAP1024B. I have reviewed the data sheet and there is nothing about T6963C compliance. I tried T6963C example provided by Mikro Elektronika. Nothing displayed on the glcd screen except some weird lines. No text and no graphics displayed on the screen.

Either do i make some mistake on the cabling ( i checked it so many ) or is SAP1024B not compliant to T6963C.

Is there anyone who knows about this controller ? I started to write a library for this controller. If it is really not compliant to T6963C, then i will stop writing a library for it.

Best regards,

FIRAT KOCAK

You'll have to sit with the datasheets from the SAP1024B and the T6963C and compare the instructions to determine if they are compatible or not.

Hi,

Thanks for the comment. It is funny how i can not think of it :) . Yes, i downloaded T6963C and it seems datasheets are the same. So i should check my cabling and connections again.

Best regards,

Firat Kocak

hi firatkocak I have your same problem and I wonder if you are able to solve ... I tried using the toshiba lib controller but do not see anything ...
I have not understood what is the pin PD "control pin for oscillation" and where I do put it... Please help me