MikroElektronika Forum

Hi,

I'm using MikroC for PIC32 with license and the MikroProg to program the MCU.

I've no problem to program the PIC but when I try to use ICD something doesen't function.

Setting correctly the project settings (Build type:ICD Rlease Debugger:MikroICD) when I click on "Start Debugger" an error windows is shown: "Mikroelektronica ICD Hardware not found".

What can I chek? Thanks for the support!

Franek

Not the same chip, but perhaps this thread can help:
http://www.mikroe.com/forum/viewtopic.php?f=106&t=36737

Hello,

Thanks OT, I believe that you are right.

Hi,

I properly set the ICD communication channel.
I powered the board with the programmer.
I set properly the Project Setting:
-Build Type: ICD Debug
-Debugger: MikroICD

but as soon as I press "Start debugger" (F9) immediatly I have the error: "Mikroelektronika ICD Hardware not found"

Simply programming the MCU no problem. What could be the problem? Thanks a lot!

Hello,

Please can you tell me, did you connected your board to power supply unit?
During ICD you need to power your chip.
You can do this by connecting external power supply, or by powering from mikroProg.
Tools >> MikroProg Power Options >> and there you should enable power supply for your board.

Best regards.