Dear all
As title.
Best Regards
May I use MPLAB ICD2 in MikroC
Re: May I use MPLAB ICD2 in MikroC
yes you can.
write your project and compile it using MikroC, then use MPLAB IC2 to upload it.
Regards
write your project and compile it using MikroC, then use MPLAB IC2 to upload it.
Regards
-
tihomir.losic
- mikroElektronika team
- Posts: 2138
- Joined: 02 Dec 2009 14:16
- Location: Serbia
- Contact:
Re: May I use MPLAB ICD2 in MikroC
Hello,
To successfully use MPLAB® ICD 2 Debugger with generated .cof file, follow the steps below :
1. First of all, start mikroC PRO for PIC and open the desired project.
2. Open Tools › Options › Output settings, and check the "Generate COFF file" option, and click the OK button.
3. Next, enable Background Debug bit in the Edit Project menu.
4. After that, compile the project by pressing Ctrl + F9.
5. Connect USB cable and turn on power supply on EasyPIC6.
6. Program the MCU by pressing F11.
7. Connect external power supply, USB cable from PC and modular interface cable to the MPLAB® ICD 2 Debugger's appropriate sockets.
For more information, please, follow this link:
http://www.mikroe.com/esupport/index.ph ... ticleid=40
Best regards,
Losic Tihomir
To successfully use MPLAB® ICD 2 Debugger with generated .cof file, follow the steps below :
1. First of all, start mikroC PRO for PIC and open the desired project.
2. Open Tools › Options › Output settings, and check the "Generate COFF file" option, and click the OK button.
3. Next, enable Background Debug bit in the Edit Project menu.
4. After that, compile the project by pressing Ctrl + F9.
5. Connect USB cable and turn on power supply on EasyPIC6.
6. Program the MCU by pressing F11.
7. Connect external power supply, USB cable from PC and modular interface cable to the MPLAB® ICD 2 Debugger's appropriate sockets.
For more information, please, follow this link:
http://www.mikroe.com/esupport/index.ph ... ticleid=40
Best regards,
Losic Tihomir
mikroElektronika [Support team]
