MikroElektronika Forum

Hi,
no one has ever made an ICSP connector for the EasyPIC5?
where i could connect my ICSP connector directly on the PICFlash circuit of my EasyPic5?

Then would be so much easy to program every PICs once installed on my final projects.

Thanks

I don't thin that the EP5 is capable of ICSP.

See here http://www.mikroe.com/forum/viewtopic.p ... ight=doing.

WARNING: Cats pictures aplenty there

Yea but thats not really ICSP.Thats HV programming.

ICSP is ICSP whatever the programming voltage. Note, that not all PICs have low-voltage programming capability.

great, i think i will do something like that

Hi,

Here is my 5 cents contribution for ICSP connector.

Plug one side to Dip connector (EasyPic)
Plug other connector to your board.
Pic is loaded on this side.
Select with 3 switch where Pic is connected : EasyPic or your board.

Hi,

i made this one because I didn't want to (couldn't) put switches on my final board. So during final dev, i could program and try my board without removing Pic.