Page 1 of 1
mikroProg Suite remark
Posted: 07 Jun 2011 10:14
by Dany
Hi, when programming a PIC24 with the lv24-33 programmer I usually see the following, the "Program Memory Size" is zero... (also after programming or a "read" action).
Thanks in advance!
Re: mikroProg Suite remark
Posted: 09 Jun 2011 14:06
by filip
Hi,
I have tried reproducing this is 1.04 and 1.10 version of the mikroProg suite, but failed to do so.
Please, can you tell me how to reproduce it ?
Regards,
Filip.
Re: mikroProg Suite remark
Posted: 09 Jun 2011 15:17
by Dany
filip wrote:Please, can you tell me how to reproduce it ?
Indeed, sometimes i have no trouble to reproduce it, sometimes it is OK.
I will try to find a way to reproduce it reliably.
Re: mikroProg Suite remark
Posted: 09 Jun 2011 18:20
by Dany
Dany wrote:filip wrote:Please, can you tell me how to reproduce it ?
Indeed, sometimes i have no trouble to reproduce it, sometimes it is OK.
I will try to find a way to reproduce it reliably.
Hi Philip,
It can be reproduced when the mikroProg suite is started up via the shortcut on the desktop. The program memory size shows 0K then.
When started from mP, the memory size shows 21K.