PIC24 and dsPIC33 Tools

LV 24-33 v6 is a development system that supports 64-, 80- and 100-pin PIC24F, PIC24H and dsPIC33F MCUs. It comes with a PIC24FJ64GA010. It features a USB 2.0 programmer with mikroICD (In-Circuit Debugger), touch panel controller, MMC/SD card slot, etc. [more info]

The Easy24-33 v6 development system supports 14-, 18-, 20- and 28-pin Microchip PIC24 and dsPIC33 devices. It comes with the a PIC24F16KA102. The system features a USB 2.0 programmer with mikroICD and many peripheral modules such as: Touch Sense, Serial RAM, EEPROM, etc. [more info]

The LV24-33A development system supports 64-, 80- and 100-pin PIC24F, PIC24H and dsPIC33F microcontrollers from Microchip. It comes with the PIC24FJ64GA010 microcontroller. The board includes an USB 2.0 programmer, mikroICD (In-Circuit Debugger) and a touch panel controller. [more info]

The LvPICFlash with mikroICD support is a USB 2.0 programmer with in-circuit debugger (mikroICD) used for programming dsPIC33 and PIC24 devices from Microchip. It is powered from a single USB port on your PC and is specifically designed for in-circuit programming. [more info]

The LV24-33A Experimental Board is used for programming LV24-33 MCU cards. It enables you to program microcontrollers in an easy way. You just have to place an MCU card on the board and start programming.       
[more info]

LV 24-33 v6 TQFP MCU Cards come with 64-, 80- or 100-pin dsPIC33 or PIC24 microcontroller in TQFP package soldered on them. There are an on-board oscillator and pads connected to the microcontroller pins. [more info]

The 100-pin TQFP MCU Card Empty PCB supports PIC24 and dsPIC33 devices in TQFP package. Customers can solder their own components on this PCB. [more info]

LV24-33 MCU Cards have either dsPIC33F or PIC24 MCU soldered on them. They are compatible with our LV 24-33 development system. Due to a two-line connector, these cards can be easily connected to the development system. [more info]

Empty LV24-33 MCU Cards are compatible with our LV 24-33 development system. You should solder your MCU and other electronic components. These cards are connected to the development system via a two-line connector. Their bottom has a ground plane for noise prevention.   [more info]