USB 2.0 on-board programmer - ARMprog: You will get the USB programmer which doesn't use boot loader or any similar way of programming. The whole ARM memory and all pins are available to you. Aside from that, you will have state-of-the-art fast USB ARM InSystem programmer for your future projects.
Our latest ARMprog Programmer is driven and powered from a single USB port on your computer. No additional AC power adapter is needed. The programmer is recognized by Windows, which simplifies driver installation. The programmer board is specifically designed for In-Circuit Serial Programming (ICSP).

The ICSP interface is a 3-wire serial protocol implemented using the MCU pins. The first MCU pin is used as a data input pin. The second pin is used for sending data from the programming executive. The third line is used for entering MCU into the programming mode. Connection to the computer is made via the universal serial port, so ARMFlash programmer can work on all computers with USB 2.0 support.

Keyboard Shortcuts

New version of software includes a number of shortcuts which facilitate programming:

• Alt-E Erase
• Alt-B Blank check
• Alt-W Write
• Alt-V Verify
• Alt-R Read
• Alt-D Change MCU
• Ctrl-S Save
• Ctrl-O Open (Load)
• Ctrl-R Reload

Command Line

Alternatively, you can use the ARMflash programmer from the command line. It will allow you to use ARMflash from some other software, compiler etc. Here are the command line parameters:

• -w Write to ARM
• -v Verify
• -r Read from ARM
• -e Erase ARM
• -p ARM name (for example LPC2148, LPC2214...)
• -f Filename (use " as delimiters)
• -b Check if ARM flash is blank
• -Q Terminate after programming
• -Uon Force Code protection
• -Uoff Force Code unprotect

Examples:

armflash.exe -w -pLPC2148 -v -f"C:\somefile.hex"

This will program the ARM using C:\somefile.hex and it will verify the write.

armflash.exe -r -pLPC2148.

This will read the ARM contents into on screen buffer.

armflash.exe -e -pLPC2148

This will erase the ARM.